Packaging format
- Code MW0954N - 100gr
- Code MW0964N - 250gr
- Code MW0974N - 1kg
All snow types
–5°/–1°C
30/60%
110/120°C
DESCRIPTION
Solid paraffin with low fluorine content for competitive use as an end product or as a base product for overlaying FP4 perfluorinated waxes. To be used for snow from -5° to -1°C. Air humidity from 30% to 60%. Hot application with a waxing iron.
APPLICATION METHODOLOGY
GENERAL PRINCIPLES
The application of hydrocarbon paraffins (Med or Soft Racing Base or BP1), fluorinated hydrocarbon paraffins (LP2 or HP3) and perfluorinated waxes FP4 allows certain overlaps based on the following chemical affinities:
Hydrocarbon paraffin alone (Med or Soft Racing Base or BP1) or mixed with other hydrocarbon paraffins;
Fluorinated hydrocarbon paraffin alone (LP2 or HP3) or mixed with other hydrocarbon paraffins;
Perfluorinated wax FP4 on its own or mixed with other perfluorinated waxes but in any case superimposed on fluorinated hydrocarbon paraffin (LP2 or HP3) .
The direction in waxing operations must always be from the tip to the tail of the tool.
Race waxing can be performed hot or cold depending on the physical state of the products and the experience of the skiman.
APPLICATION METHOD WITH WAXING IRON
- Rub the paraffin lump all over the base, leaving an even layer of product.
- Using the waxing iron at a temperature of 120°C., melt the wax in a regular forward and backward motion and then make a continuous pass from tip to tail at a constant speed (approx. 5 cm per second).
- Wait at least 15 minutes to allow the wax to solidify and the base to cool;
- Remove excess wax with a well-sharpened Plexiglas spatula, exerting little pressure;
- Remove the solidified paraffin from the side of the ski and the side of the edges;
- Free the impression with a stiff nylon hand brush;
- Brush the impression with a manual or rotating stiff horsehair brush;
- Polish the impression with hand brush or rotating soft nylon brush.
